Quick Answer: How Do You Test A GM Ignition Coil With A Multimeter?

How many volts are in an ignition coil?

Modern coil designs produce voltage pulses up in the neighborhood of 40,000 volts from the interruption of the 12 volt power supplied by the battery.

Some modern engines have multiple ignition coils mounted directly on the sparkplugs..

How do you test an ignition coil with a multimeter?

Connect your multimeter to the positive terminal or pin of your coil, and to the high output terminal that goes to the spark plug. Most ignition coils should have a secondary resistance falling somewhere between 6,000 to 10,000 ohms;however, refer to manufacturer specifications for the correct range.

How can you tell if an ignition coil is bad?

Symptoms of a Bad or Failing Ignition CoilEngine misfires, rough idle, and loss of power. One of the most common symptoms associated with a faulty ignition coil is engine performance issues. … Check Engine Light comes on. Another symptom of a potential issue with the vehicle’s ignition coils is an illuminated Check Engine Light. … Car is not starting.

Can AutoZone test an ignition coil?

Bad spark plugs or plug wires overload the ignition coils. … It’s easy enough to test your vehicle’s ignition coils yourself with a few tools from your local AutoZone. Even if you get a normal reading, ruling them out as the problem can help you narrow the issue with the ignition system.

Can a bad ignition coil cause transmission problems?

A bad ignition module can manifest in many ways, including idle issues. You might look into the transmission itself if the car jerks going into gear, and you don’t get a check-engine light or vibration indicating misfire.

Is it OK to drive with a bad ignition coil?

The answer is you should not. You can drive the car until it breaks down completely (and it will). While doing so you will, as pointed out by other answers, run the risk of damaging the converter but you also run the risk of fire. If the coil is faulty very bad things can happen.

Can a ignition coil get weak?

Most ignition coils are long lasting and reliable, but a weak coil you can be the cause of under-hood havoc. You cannot operate a car smoothly without delivering high voltage to the spark plugs to ignite the air-fuel mixture. Most coil failures result from secondary winding defects.

How do you test a 12v ignition coil?

How to Test 12 Volt Ignition CoilsDisconnect your engine’s main negative battery cable with a wrench.Pull the main ignition coil wire, the one that leads to the distributor, off the coil. … Turn on the multimeter and set it to the “ohms” function.More items…

Can you test spark plug with multimeter?

An Ohm meter, which is part of a multimeter, can only check a spark plug for a short circuit or a breakdown of insulation resistance. A good spark plug should show an open circuit between the center electrode and the tip. Any resistance at all would mean the plug is bad.

How do you test a GM coil pack with a multimeter?

Turn the multimeter on. Attach the its red lead to the right terminal, then attach the black lead to the left terminal. Read the voltage displayed on the multimeter. Your coil pack is properly powered if the reading is 11 to 12 volts.

Is it hard to change an ignition coil?

Changing ignition coil is easy enough that you can do it on your own. Just make sure that you have the correct tools and the right replacement part.

What makes ignition coils go bad?

Ignition coils tend to fail because of bad spark plugs or plug wires. If your vehicle’s fuel-to-oxygen mixture is either rich or lean, therefore, your ignition coils may fail prematurely. Additionally, engine heat and vibrations can cause damage to ignition coils.

How long do ignition coils last?

The ignition coil on your car is supposed to last around 100,000 miles or more. There are a number of factors that can lead to this part become damaged prematurely.